The 3rd SD card has been unsuccessful, as well. Today, after a couple of hours working on the same project, it happened again. Yesterday when this happened, I proceeded to follow the referenced article above and replaced the Original SD card I received in October with a spare. If the problem persists, delete the device in the LightBurn Devices and re-add it.Unplug Cohesion3D power supply (important).
It has been getting increasingly stubborn to resolve.
This has been happening approximately 1 in 10 uses for me since purchase in 10/2021. Then it proceeded bumping against the left boundary persistently trying to move left to finish the remaining images. When I started the project, it started the right side of the project in the top left corner of the workspace near the left boundary (Position Y: 170mm, X: 20mm) and proceeded with all cuts. So, I moved my project to the right side of the board in LB. Today after the first LB project run on the left half of my board, I wanted to reuse the remaining 50% on the right half of my board to duplicate the LB project. I have been testing this project for the past week. Today’s scenario: I performed some test cuts that used 50% of my project board. It is important to note, Home and Origin do not change. “ When I send a project at the laser it starts engraving in an obviously wrong location and if i let it go for long it will slam the head against the zero X rail and then proceed to another area.”
Using Lightburn, I can home no issue and can send the head to any position from the Move tab without any problem. I don’t know that it was the Windows update that did it, but the two things coincide. On Friday Microsoft forced an update of Windows 10 onto my PC and now when I go to use Lightburn with my Cohesion 3D controller on K40 things are not going right. I don’t know if this is a Laserboard issue or a Lightburn issue or a Windows issue so I’ve posted this on the Lightburn forum also. Cohesion 3D & Lightburn in Window 10 new issue Board Configuration and Setup
0 kommentar(er)
